The Adams Rite driver replaces the actions of the
The important parts to know are the latchbolt, the dead latch and the internal latch.
When the Dead latch is pushed in the latchbolt is blocked from sliding in.
To By-Pass the
Once the Driver is through the keyway and out the cam simply rotate the driver to depress the internal latch and pull it across. This will then also pull in the latchbolt unlocking the door.
Tips & Problems
- Some cams have a solid back preventing access to the internals. You can check with a tension wrench to see if you are block.
- The Latchbolt can be wedged between the door and the frame putting to much pressure on the internals for the driver to slide the internal latch across (it will be able to push it down allowing it to slide). In this situation use some Sparrows quick shims or a slim Jim to slide the door latch across after the driver has depressed the internal latch.
- Putting pressure underneath the latchbolt with a Sparrow Quick Shim or Slim Jim will angle the internal latch in a beneficial way making it even easier for the driver to grab. The 4900 model has a lot of play in this aspect and the internal latch will move quite a bit making it the easiest of the Adams rite models to open.
- On some cylinders their can be a very tiny gap between the cylinder and the cam inside the keyway. The tip of the driver might get caught on this lip. You can slide a narrow tension wrench down the keyway to help push the tip out of this gap and all the way through the cylinder. Then just pull out the tension wrench and continue normally.